Sunday, June 30, 2013

Check Point Gaia: How Do I View The Routing Table In CLI?

Ive needed to do this, but not in WebUI.  In CLI.  Here is the command I run to do this:
CP1> netstat -rn
Kernel IP routing table
Destination     Gateway         Genmask         Flags   MSS Window  irtt Iface
87.87.95.23 0.0.0.0         255.255.255.192  U         0 0                 0 eth2
10.8.1.0       0.0.0.0         255.255.255.0      U         0 0                 0 eth1
172.16.78.0     0.0.0.0         255.255.255.0   U        0 0                 0 eth4
10.0.0.0        172.16.78.1       255.0.0.0       UGD    0 0                 0 eth4
0.0.0.0         87.87.95.24          0.0.0.0         UGD    0 0                 0 eth2
Posted by

1 comment:

  1. AnonymousAugust 14, 2014 at 4:05 AM

    Also you can do :
    non-expert
    >show route
    expert
    >route

    ReplyDelete

Your comment will be reviewed for approval. Thank you for submitting your comments.

Subscribe to: Post Comments (Atom)