Sometimes I just need to see if a port is up or not. I dont need all the statistics. So when I do a show interface eth 1/2/2 on the switch, I dont want to wait for the console to scroll down. I just want a short answer, is the port up or not. Here is the commmand to do just that.
ICX6450#sh int bri eth 1/2/2
Port Link State Dupl Speed Trunk Tag Pvid Pri MAC Name
1/2/2 Down None None None None Yes N/A 0 cc4e.2463.xxxx
ICX6450#
ICX6450#
No comments:
Post a Comment
Your comment will be reviewed for approval. Thank you for submitting your comments.